Manuscript Packet

KDP trim sizes and margins, explained

Which trim size to pick for a paperback, and the exact inside, outside, top and bottom margins KDP requires at every page count.

Updated

Trim size is the finished size of the printed book. It is the first print decision to make, because it sets how many words fit on a page, how many pages the book runs to, what each copy costs to print and what size the cover needs to be. Margins come second, and KDP is strict about them: a PDF with text too close to the edge or the spine gets rejected.

The trim sizes most novels and nonfiction use

KDP offers more than a dozen trim sizes, but a handful cover almost every trade paperback. All of these are also standard at IngramSpark, so one PDF works for both.

Trim sizeTypical useFeel
5 × 8 inNovels, novellas, poetryCompact, easy to hold
5.25 × 8 inFictionA little wider than 5 × 8
5.5 × 8.5 inFiction, memoirThe classic “digest” size
6 × 9 inNonfiction, longer novelsThe US trade paperback standard

If you are unsure, 6 × 9 is the safe default for nonfiction and 5.5 × 8.5 for fiction. A larger page holds more words, so the same manuscript prints on fewer pages, and fewer pages means a lower print cost per copy. The trade-off is a slimmer spine and a book that can feel less substantial in the hand.

Page count limits

KDP prints paperbacks from 24 to 828 pages at the common trim sizes. IngramSpark’s minimum is 18 pages. KDP only prints text on the spine when the book has more than 79 pages, so a shorter book gets a blank spine.

KDP’s minimum margins

Margins are measured from the trim edge to your text. The inside margin, also called the gutter, is the one next to the spine. It has to grow as the book gets thicker, because a thick book curves more into the binding and text near the spine disappears into the fold.

Page countMinimum inside margin
24–1500.375 in (9.6 mm)
151–3000.5 in (12.7 mm)
301–5000.625 in (15.9 mm)
501–7000.75 in (19.1 mm)
701–8280.875 in (22.3 mm)

The outside, top and bottom margins must be at least 0.25 in (6.4 mm) for a book without bleed, and at least 0.375 in (9.6 mm) with bleed. Bleed only matters if images or colour run off the edge of the page. A text-only book does not need it.

Minimum is not the same as good

KDP’s numbers are the floor for getting accepted, not a recommendation. A page set at the minimums looks crowded and cheap. Professionally designed paperbacks use noticeably wider margins, and the inside is usually a little wider than the outside so the text block looks centred once the book is open.

As a starting point for a 6 × 9 in novel or nonfiction book:

  • Inside margin around 0.875 in, and never below KDP’s minimum for your page count.
  • Outside margin around 0.625 in.
  • Top margin around 0.75 in, with the running head sitting inside it.
  • Bottom margin around 0.85 in, with room for the page number.

Smaller trims scale these down slightly. These are the values Manuscript Packet uses, and it widens the gutter automatically for very long books so the PDF always meets KDP’s table above.

Mirrored margins

In a printed book the gutter is on the right of a left-hand page and on the left of a right-hand page. Your PDF needs “mirrored” margins to match. If you format in Word, turn on Layout → Margins → Mirrored and set the inside value. If the PDF has the same left and right margin on every page, the text will sit off-centre in half of the printed book.

Before you upload

  • The PDF page size must match the trim size you choose in KDP exactly.
  • All fonts must be embedded in the PDF.
  • Page count affects the spine width, so finish the interior before you order a cover. The spine width calculator gives you the numbers.

For the full list of things to check, see the print-ready interior checklist.

Figures from KDP’s published paperback specifications, checked September 2026. Amazon updates these from time to time, so confirm on KDP’s help pages before you publish.